Need help with starter clutch ...

[TLRam1]

I did have to pull the little roller pin out of the original and transfer it over and it was a bit of a challenge getting it out

Are you referring to one of the three rollers or something else?

And where is your video Charlie?  Looks like we need a new for for the 3rd Gen Magnas and I don't think Hoot will make it over.

[LIMagna]

I did have to pull the little roller pin out of the original and transfer it over and it was a bit of a challenge getting it out

Are you referring to one of the three rollers or something else?

  Something else ... part # 17 in the parts fiche:

http://www.ronayers.com/PULSE-GENERATOR-C190521.aspx

It fits into a little recession in the starter clutch flange/cover.  I'm not sure what the purpose of it is other than to align the flange with the clutch body.  Since the flange is keyed to go on the shaft only one way, that would put the pulse generator pickup points on the outside of the clutch body in the proper position. 

And where is your video Charlie?  Looks like we need a new for for the 3rd Gen Magnas and I don't think Hoot will make it over.

  Sorry, no video but the repair was relatively easy.  Just watch the force you use on the bolts when you put the crankcase cover back on 

[hootmon]

It must be easy.. I've done it and succeeded!!! 

[TLRam1]

I see what you are talking about now Charlie.

[TLRam1]

It must be easy.. I've done it and succeeded!!! 

What pressure you add to me......now when failure comes I shall NOT post.