Maintenance alert!!

Started by Greg Cothern, July 31, 2006, 06:34:31 PM

Previous topic - Next topic

Greg Cothern

Maintenance alert!!  I had a guy email me with a scenario that I had not encountered before but immediately knew the reason.
He said "that the speedo drive gear and the end of the speedo cable after only about 20 minutes of riding. The bottom of the fork feels very hot at this point but the brake disc feels normal and the other side of the axle feels OK."
Wheel Bearing!!!!!  Remember if you ride in the rain quite a bit, or wash you bike with a pressure washer you need to check them often and replace them more frequently.  Someone a while back listed some part #'s and vehicles that use the exact same wheel bearing for much cheaper than stock.  Hopefully they will refresh our memories with that information??
Greg Cothern
00 Valkyrie Interstate
96 Magna 
Previously owned:
87 Super
96 Magna project bike
95 Magna "Pay it forward"   

kdf9511

Good reminder Greg.  I should get new bearings for the wheel I am going to swap out on Val.

MagnaMan

Greg. What's a good way to test the bearings? Spin them and listen for noise?
Jesse
Moot #358
'99 Magna (Halloween theme paint job)
Racetech Cartridge Emulators in front forks, Progressive 444s on the rear. Best mods I've ever made to this bike.
Houston

Greg Cothern

Best way for me is to remove the wheel and use my finger to rotate the bearing.  It should feel smooth and not rough or gritty.
Greg Cothern
00 Valkyrie Interstate
96 Magna 
Previously owned:
87 Super
96 Magna project bike
95 Magna "Pay it forward"