Hi all I was wondering when I get home I have to pull the carbs and clean them my friend that I got the bike from let it sit with gas in the carbs ugh.
Got it running but what fun had to pull the choke to get it running and run it up and down the street finally got it cleared but it won't idle so the only thing I can think is tear them down... Idle jets are surely clogged..
First ??? are the idle or slow jets #40 it has cobra drags on it so I am sure it has a jet kit it runs great and ran great when I did the tune up for him last year then it sat hahahahah poor baby....Can't wait to get home and go riding and meet some of you all!!!
Have you tried running some Techron or even plain old ATF fluid through a couple of tanks of gas?
Lots of times that will clear those kinds of things right up.
Nope but that is the first thing I will do any kind of ATF or just the cheap stuff
I've never done it myself, always used Techron but knowledgable folks have indicated that a half a bottle or so of plain old decron type III ATF will do the same thing that techron does.
As always, YMMV so try it at your own risk.
Marc.
No problem with that it's always my fault hahahah I don't mind tearing them down but would like to do a wrench session with that....
I am always willing to help out with Carb cleaning and such, if you willing to make the ride here.
I am thinking about it have a few things to take care of when I get off the boat but and definatly milling it over....
Try adding some Seafoam to the gas, it works very well. You can get it at NAPA.
Going to have to look in to that for sure
Success well so far she runs and idles got lucky now to change the oil and coolant Man does she fly heheheheh got goose bumps turns are great almost went back to the old days and put my knee out lolololol :twisted:
What did you end up ising to clean out your carbs? ATF, Techron or SeaFoam? None of the above? All of the above? LOL
Well alittle of ATF and STP carb cleaner and also took the air filter off and sprayed carb cleaner in the ports and around and in the carb bells while she was running. Still going to try and see if I can make it to Gregs when I get off the boat if he is free. Which would put me there on the 3rd or 4th or Sept. Still has a stumble around what I would call the cruise speed or mid range but Idles well and when you hit the throttle it goes like a rocket but when you are just going or just above idle she pops and sputters. Just have barely half a tank thru it I rode it around the house and then to work so about 70 or so miles on the souped up tank hahahaha anyhow thanks for all the input and will keep you posted....
Whenever you can make it we will get her taken care of. Sounds like you need to order a set of Dave Dodge needle shims and jets,
DODGE RACING PRODUCTS
Tel: (704) 892-7961
Fax: (704) 892-7961
Give Dave a call.