I have 22k miles on this chain and it is adjusted to the red zone. I also hear some noise when riding and notice a link or two that does not re-form with the group.
I bought a new one from Cyclegear for $104 but need the rivet tool to take off the old and put on the new link since it is not the clip type. WoW! $99 for the tool. I will be checking ebay but may bite the bullet and get it from cyclegear.
Seems like an easy job if you don't want to take off the rear wheel. I hope to tackle the job at Greg's wrench session if I do not get to it before.
What is your typical mleage for a chain? This chain has been wax lubed for 18k miles.
Bob #69
Don't forget the front, drive, and rear, driven, sprockets. :shock: If there is any wear to either of them you need to replace them at the same time. :( If you don't, your milage on the new chain will be reduced. :evil: A worn sprocket will eat up a new chain in no time. :evil:
I usually change, or should say have changed, all three at the same time. I usually get anywhere from 18 to 22 k miles out of a set of sprockets and chain. Up till now all I have used is the spray wax on the chain but am now trying the grease that JR has talked about. Just started my test with it so I can't report either way yet. :?