Charging issue....

hootmon · June 04, 2012, 09:20:34 PM

Mod completed...
They will also need to move the grommets (the sealing rubber where the wires go thru the case) up about 3/4" also... I was not able to add the bracket that covers the wires thru the channel inside the case...
I will inform them tomorrow...
All three covers are back on and wires threaded up to under the seat... I'll finish tomorrow, and see if things work...

TLRam1 · June 04, 2012, 10:08:12 PM

Hello, Mod Photos?

hootmon · June 08, 2012, 04:43:02 PM

Got the bike 90% done last night, and it's charging!!!
I few more odds and ends tonight, and should be back on the road...

roboto65 · June 08, 2012, 05:31:29 PM

Just in time for MOOTMag

hootmon · June 08, 2012, 07:49:19 PM

Quote from: roboto65 on June 08, 2012, 05:31:29 PM
Just in time for MOOTMag

This is my wife's VT Sabre...

TLRam1 · June 09, 2012, 01:05:59 AM

So she can come with you.

rjb/AKA Bob Barram · June 09, 2012, 11:22:18 AM

Good Ole Terry, always the optimist....

hootmon · June 09, 2012, 11:22:43 AM

Good news.. bike is back together and charging..
Bad news.. bike is breaking up like the rev limiter is kicking in when I accelerate hard ..
Hummm..

hootmon · June 09, 2012, 01:27:31 PM

Found the issue...
This bikes air intake is under the seat
The regulator/Stator connectors are just in front of the intake.
There is a large rubber boot that you place over the connectors.
The boot fell off and was laying on top of the intake, starving the motor under hard acceleration.
I zip tied the boot on and all is well...