Motion Pro Carb sync tool

[dgc67]

Thanks to some awesome help from member Chad I am working on getting my "official" sync done today.  Only posting this for anyone who uses the Motion Pro.  I had an issue where:
1. I used it wrong
2. It had sat too long without cleaning.

Upon following instruction's (and some fluid, Thank you Chad!) from Chad I realized my outer to lines were partially clogged with the fluid.  I have flushed water through them and blown air 3 times now (per instructions for it) and STILL there is residual fluid.  I have it soaking in hot soapy water now.

So, my advice based on this experience is:
1. Wash them out when your done and do not replace fluid till you need to use it again.
2. Keep spare bottle of fluid on hand.  Not expensive, about $5.
3. "Sync" the synchronizer when you start.

Later today I will do an official sync and report how off they were.  Mind you, this set was never bench synchronized.  Only torn apart as far as you can tear em' apart. 

[Chad in Michigan]

if you can't get 'em clean for some reason, i have 3 good plastic tubes left with 4 of the rubber o-rings

[dgc67]

They cleaned up nice after a good soaking and some air.  I never got around to doing the sync today though.  Such a beautiful day here, went for a ride and did stuff in the yard.  Got my generator cleaned up and ran it a little in prep for Hurricane season.